Start Recording - Kenwood HM-333 Instruction Manual

menu
volume / multi control
set / demo
3 3
Select an input source other
than "TAPE"
Example:
To select the CD input
CD
6
TAPE rec
Pause the recording
TAPE rec
÷ Press the TAPE rec key during recording. It stops
after leaving a non-recorded blank of 4 seconds.
(Press the key again to resume recording.)
3. Set the recording condition.
Select the reverse mode. ¡
÷ Check the tape transport direction before starting recording. If it is set to
the reverse direction, only one side of tape can be recorded regardless of
the reverse mode setting made here.
÷ The tape equalizer is defeated during recording.
4. Select the source to be recorded.
CD
TUNER (Broadcasts)
AUX (External input) [Adjusting the AUX input level °]
÷ If a CD has already been loaded, it starts to
play now. Press the 7 STOP key to stop it.
4 4

5. Start recording.

1
Press the TAPE rec key.
2
Play (or tune) the input source to be recorded.
5 5
÷ Recording stops automatically when the tape side (s) to be recorded have
been fully recorded.
Lights
Stop the recording
Recording on TAPE
C D
The character information
display shows the recording
input source.
7
stop
Tuning
Mode
29