Tuning A Non-Preset Radio Station (Auto Tuning, Manual Tuning); One-By-One Presetting (Manual Preset) - Kenwood HM-333 Instruction Manual

24
Tuning a non-preset radio station
Select the tuning mode according to the radio
wave receiving condition.
When the receiving condition is good: AUTO
mode
When it is poor due to weak radio waves:
MANUAL mode
1 Select the AUTO or MANUAL mode.
STOP 7
2 Tune a station.
1
To decrease
frequency
One-by-one presetting
Remote control unit only
1 Perform the procedure in "Tuning a non-
preset radio station (Auto tuning, Manual
tuning)" to receive the station to be preset.
2 Press the ENTER key during reception.
(Proceed to step 3 while "MEMORY" is lit.)
3 Select one of the preset numbers from
1 to 30.
4 4
P.CALL
4 Press the ENTER key again.
(Repeat steps 1, 2, 3 and 4 to preset other sta-
tions)
(Auto tuning, Manual tuning)
AUTO/MONO
1
TUNING
To increase
frequency
(Manual preset)
ENTER
1 2 3
4 5 6
7 8 9
10 0
ENTER
÷ In MANUAL mode, FM stations are received in monau-
ral.
Each press alternates the mode.
1 "AUTO" :
Stereo reception("AUTO" lit)
2 "MANUAL" :
Monaural reception ("AUTO" not lit)
÷ Normally, use the AUTO (Auto tuning, stereo reception)
mode.
In AUTO mode :
The next preset station can be received automatically
every time the TUNING UP/DOWN (1 or ¡) key is
pressed.
In MANUAL mode :
Press the TUNING UP/DOWN (1 or ¡) key repeat-
edly until the desired station is received. The desired
station can also be received by holding the TUNING
UP/DOWN (1 or ¡) key depressed until its fre-
quency is displayed.
M E M O R Y
"MEMORY" lights (for approx. 20 sec.)
÷ A maximum of 30 stations of the band presently being
received will be preset.
÷ If several stations are preset under the same number,
the previous memory is replaced with the latest
memory contents.
Receiving broadcast station Playback of tape