Prestige 100IH User's Guide
LAN-to-LAN Application
A typical LAN-to-LAN application is to use the Prestige to call from a branch
office to the headquarters. Up to four users can access the Prestige
simultaneously on the LAN as depicted in the following diagram:
Figure 8-1 LAN-to-LAN Application
For the branch office, you need to configure a Remote Node in order to dial
out to the headquarters. Additionally, you may also need to configure Static
Routes if some services reside beyond the immediate remote LAN.
Remote Node Setup
Follow the procedures in Chapter 6 to fill the protocol-independent
parameters in Menu 11, Remote Node Profile. For the protocol-dependent
parameters, follow the instructions below. If you are configuring the Prestige
TCP/IP Configuration
Number of Bits
4
5
6
7
8
Dot Decimal
240
248
252
254
255
ZyXEL
Page 59