Laser Information; Battery Notices - Wasp HC1 User Manual

Laser Information

The Wasp HC1 series is certified in the U.S. to conform to the requirements of DHHS/CDRH 21CFR
Subchapter J and to the requirements of IEC 825-1. Class II and Class 2 products are not considered
to be hazardous. The HC1 series contains internally a Visible Laser Diode (VLD) whose emissions do
not exceed the maximum limits as set forth in the above regulations. The scanner is designed so that
there is no human access to harmful laser light during normal operation, user maintenance or
prescribed service operations.
The laser safety warning label required by the DHHS/IEC for the HC1 series' optional laser scanner
module is located on the memory compartment cover, on the back of the unit.
Caution: Use of controls or adjustments or performance of procedures other than those specified
herein may result in hazardous laser light. Use of optical instruments with the scanner, including
binoculars, microscopes, and magnifying glasses, with will increase eye damage. This does not include
eyeglasses worn by the user.

Battery Notices

The HC1 is equipped with a Lithium-Ion battery pack and a Ni-Mh backup battery. Both batteries will
discharge after an extended period of no use.
When both batteries are discharged, recharge the unit for 12 hours in order to fully charge the main
battery and backup battery. Recharge the HC1 battery by doing the following:
1. Plug the USB charging cable into the HC1 and plug the 5V/3A AC-DC adapter into the power
jack of the USB charging cable.
2. Place the HC1 into the docking station and plug the 5V/3A AC-DC adapter into the power jack
of the docking station.
vi
Wasp HC1 User Manual