Getting The Most From Your Remote Control - Kenwood KRF-V8030D Instruction Manual

Getting the most from your remote control

The remote control supplied with this receiver is also
capable of controlling components from a variety of manu-
facturers once you register the appropriate setup codes
into the remote control unit.
Refer to "Remote operation of other components" for de-
tails about the operations available for each component.
Low battery warning
Replace all four batteries with new ones when you notice a shortening
of the distance from which the remote control will operate. The remote
control is designed to retain setup codes in memory while you change
batteries.
How to use the display operation keys
To register the setup code, use the display operation 1 key, display
5/∞
operation 2 key, or keys.
Display
Display operation 1
Display operation 2
The display operation 1 key and display operation 2 key work as the
function key displayed in the display above.
The display operation 1 key
• [Back]
• [Home]
>05.VCR
>06.Cable
• [Clr]
Back Enter
The display operation 2 key
• [Enter]
• [Menu]
• [Setup]
• [Exit]
• [Sel]
When the display goes off
The display goes off automatically when you do not operate for more than
8 seconds. In this case, press the display operation 1 key, display
5/∞
operation 2 key, or keys.
When you are confused about what's being displayed
Press the display operation 1 key repeatedly until "Menu" appears in the
display.
The display returns to the initial display.
5/∞
+ +
– –
Go back to the previous display.
Go back to the initial display.
Erase the internal memory.
Enter the selected item.
Display the menu.
Go to the setup display.
Exit from the current operation.
Select the item.
Registering setup codes for other components
Display operation 1
Display operation 2
!
1
Press the display operation 1 key repeatedly until
" Menu " appears in the display.
Video1:
VCR
Menu
For step 1 through step @, make sure you start the next step
within 8 seconds of completing the previous one. If more than
8 seconds elapses between any two steps, press the display
operation keys so that the display appears.
2
Press the display operation 2 [Menu] key repeatedly until
" 01.IR " appears in the display.
• The setup display appears.
>01.IR
>02.Surround
Home Enter
3
Press the 5 / ∞ keys to select " 01.IR ," then press the
display operation 2 [Enter] key.
• The input selecting display appears.
>03.Video1
>04.Video2
Back Enter
• At this time all inputs become available regardless of any earlier
registration.
4
Press the 5 / ∞ keys to select the input that you want to
register.
• Each time you press the 5/∞ key, the input changes as follows:
01:
02:
03:
04:
05:
06:
07:
08:
09:
10:
• Example: To select the source connected the VIDEO1 jack, select
"Video1".
Display
5/∞
+ +
– –
CD/DVD
MD/Tape
Video1
Video2
Video3
DVD
TV1
TV2
Cable
Phono
Continued to next page
31