Table of Contents
Advertisement
Remote control operation
|
In addition to the remote control of the receiver unit, the provided remote control unit can control
a KENWOOD
cassette tape
deck, CD player, turntable, graphic equalizer, etc., connected via the KENWOOD
system control cords.
@
While gently pressing the cover located on the rear of the
remote control unit, slide it in the direction of the arrow.
Replacing batteries
1.
If the TRANSMIT indicator does not light even when the
operation key is pressed, the batteries are exhausted.
Replace the batteries. We recommend that the alkaline
batteries (LRO3/AM-4) which have longer service life be
used.
. The programmed
contents
are not immediately
lost
when the batteries are removed for replacement.
However, they could be lost if the unit is left without
batteries for more than 3 minutes. In such a case, the
programming should be performed again. The function
signals of the non-learning, or fixed keys are not lost
even in this case.
Note:
Avoid using old and new batteries together, as this may cause Cor-
rosion.
@
Make sure that the batteries are inserted as indicated with
the polarity marking on the bottom.
Note:
The batteries provided are to be used for checking the remote
control operations. Their service life may be short.
3 Close the cover.
32 kR-vg030 (En)
@ Operating range of the remote
control unit
The normal operating range may change depending on tem-
perature, humidity, and other environmental conditions, but
it is roughly specified as shown in the figure.
Cl Remote control
light receptor
Approx. 6 m
|
Model: RC-150
Infrared system
Note:
1.
\f two or more remote contro! operation keys are to be pressed
successively, press each key securely and leave an interval of more
than 1 second between presses.
Pressing a key immediately after pressing another key may cause
malfunction.
:
. Malfunction may occur in case direct sunlight or the light of
ahigh-
frequency lighting fluorescent lamp enters the remote control Fight
receptor. In sucha
case, change the installtion position of the unit
so that the malfunction does not occur.
Advertisement
Table of Contents
