Raymarine ST60 Owner's Handbook Manual page 33

Chapter 3: Installation
2. Ensure that:
3. Apply the flush mount template (supplied at the rear of this hand-
4. Cut out the aperture (3) for the assembled instrument and bezel and
5. Peel off the protective sheet from the self-adhesive gasket (4) then
Flush mounting
6. Screw the two fixing studs (1) into the threaded sockets on the rear of
7. Mount the assembled instrument, studs, bezel and gasket into the
8. Locate the flush mount bracket (6) onto the fixing studs and secure
• The panel on which you intend to mount the instrument is
between 3 mm and 20 mm thickness.
• The selected location is clean, smooth and flat.
• There is sufficient space behind the selected location to accom-
modate the rear of the instrument and connectors.
book) to the selected location and mark out the aperture into which
the assembled instrument and bezel will sit.
remove the template.
stick the gasket into position on the rear of the bezel.
the instrument.
panel.
the assembly to the panel with the thumb-nuts (5).
21
D4335-3