Raymarine ST60 Owner's Handbook Manual page 17

Chapter 1: Operation
Race-start
timer 1
To enter/leave
adjust mode, press
reset
timer and
momentarily
Using timer key
If you are using one of the race-start timers and the timer buzzer is
enabled, the buzzer will:
•
•
•
•
The timer buzzer is enabled or disabled as part of the calibration
procedure (see Chapter 4, Calibration).
Note: After a race-start timer has counted-down to zero, it will then start
counting up.
Count-up
timer
timer
either momentarily
to start timer, or for lap time (when running)
or for 1 s to reset timer to the start value.
Race-start timer adjust
To set a different value, press
timer
to decrease the value
Double-beep every minute.
Beep three times at the start of the last 30 seconds.
Beep once for each of the last 10 seconds.
Beep for 2 seconds at zero.
timer
Press
reset
timer
reset
to increase the value
timer
Race-start
timer 2
To enter/leave
adjust mode, press
timer
and
momentarily
5
reset
D4365-3