Raymarine ST60 Owner's Handbook Manual page 37

Chapter 3: Installation
This requirement depends on the total length of the cable run and the total
number of instruments in the system, as follows:
Cable run
Up to 10 m
Up to 20 m
(typically provided
SeaTalk power connections
Stand alone instruments
Stand-alone instruments are not connected to SeaTalk and therefore need
to be connected to an alternative 12 V power source. Power cables are
available in 2 m and 9 m lengths.
To fit a power cable:
1. Ensure the intended power source is switched off. If you are using a
2. Run the power cable from the instrument to a suitable 12 V dc power
3. If the cable has not already been trimmed at the power supply end:
4. Cut the cable to length and trim back an appropriate amount of the
5. Cut back and insulate the yellow wire.
6. Connect the screen to the power supply 0 V terminal.
Red
5 A fused,
12 V dc supply
by autopilot)
Screen
Red
Screen
12 V battery, ensure the power cable is not connected to the battery.
source.
outer sheath.
No. of instruments
13 maximum
26 maximum
7 maximum
13 maximum
1 2
20
19
Power connections
1
2
1
2
3 4
Instruments
5 to 16
17
18
D4311-2
25