Raymarine ST60 Owner's Handbook Manual page 32

20
4. Snap the low-profile bezel (8) in position over the instrument, so that
Fitting the low-profile bezel
CAUTION:
It is essential that only screws of the correct size are used to secure the
instrument to the bezel. Failure to observe this caution could result
in damage to both the instrument and the bezel.
5. Using the four, self-tapping screws (9) provided, secure the instru-
Flush mounting procedure
Flush mount your instrument (see the Flush mounting illustration) as
follows:
1. Assemble the ST60 instrument and low-profile bezel as described
the rubber keys are correctly located in the holes on the bezel.
ment and bezel together. Fit the screws from the rear of the instrument
and tighten them sufficiently to secure the instrument and bezel
together. DO NOT OVERTIGHTEN.
under Fitting the low-profile bezel.
ST60 Speed Instrument Owner's Manual
8 7 9
D4360-2