Basic Engine - MULTIQUIP Whiteman J36H55 Operation And Parts Manual

INITIAL SERVICING
The engine (Figure 4) must be checked for proper lubrication and
filled with fuel prior to operation. Refer to the manufacturer's engine
manual for instructions & details of operation and servicing. The
engine shown above is a HONDA engine, operation for other
types of engines may vary somewhat.
1. Fuel Filler Cap – Remove this cap to add unleaded
gasoline to the fuel tank. Make sure cap is tightened
securely. DO NOT over fill.
DANGER
Adding fuel to the tank should be done only
when the engine is stopped and has had an
opportunity to cool down. In the event of a fuel
spill, DO NOT attempt to start the engine until
the fuel residue has been completely wiped
up, and the area surrounding the engine is dry.
2. Throttle Lever – Used to adjust engine RPM speed (lever
advanced forward SLOW , lever back toward operator
FAST ).
Engine ON/OFF Switch – ON position permits engine
3.
starting, OFF position stops engine operation.
4. Recoil Starter (pull rope) – Manual-starting method. Pull
the starter grip until resistance is felt, then pull briskly and
smoothly.
PAGE 18 — J36/M30 WALK-BEHIND TROWEL — OPERATION AND PARTS MANUAL — REV. #10 (05/07/12)
Figure 4. Engine Controls and Components
Fuel Valve Lever – OPEN to let fuel flow, CLOSE to stop
5.
the flow of fuel.
Choke Lever – Used in the starting of a cold engine, or in
6.
cold weather conditions. The choke enriches the fuel
mixture.
Air Cleaner – Prevents dirt and other debris from entering
7.
the fuel system. Remove wing-nut on top of air filter
cannister to gain access to filter element.
NOTICE
Operating the engine without an air filter, with a damaged
air filter, or a filter in need of replacement will allow dirt to
enter the engine, causing rapid engine wear.
8. Spark Plug – Provides spark to the ignition system. Set
spark plug gap according to engine manufacturer's
instructions. Clean spark plug once a week.
Muffler – Used to reduce noise and emissions.
9.
10. Fuel Tank – Holds unleaded gasoline. For additional
information refer to engine owner's manual.
11. Oil Drain Plug – Remove this plug to remove oil from the
engine's crankcase.
12. Dipstick/Oil Filler Cap – Remove this cap to determine if
the engine oil is low. Add oil through this filler port as
recommended in Table 4.

BASIC ENGINE