Table of Contents
Advertisement
BASIC ENGINE - DIESEL
INITIAL SERVICING
The diesel engine (Figure 6) must be checked for proper lubrication
and filled with fuel prior to operation. Refer to the manufacturer's
engine manual for instructions & details of operation and servicing.
The engine shown above is a Briggs & Stratton Vanguard Diesel
engine. Operation for other types of engines may vary somewhat.
1.
Engine Tag – Provided engine model identification and
information.
2.
Muffler – Used to reduce noise and emissions.
WARNING
WARNING
WARNING
WARNING
WARNING
Engine components can generate extreme
heat. To prevent burns, DO NOT touch these
areas while the engine is running or
immediately after operating. NEVER operate
the engine with the muffler removed.
3.
Fuel Injectors – Provides diesel fuel mixture to combustion
chambers.
4.
Glow Plug – Energizes to aid in cold starting.
5.
Throttle lever – Controlled by accelerator pedal, increases
or decreases engine RPM.
HHN-34TVD • RIDE-ON POWER TROWEL — OPERATION MANUAL — REV. #1 (05/08/06) — PAGE 23
HHN 34TVD — BASIC ENGINE - DIESEL
Figure 6. Diesel Engine Controls and Components
6.
7.
8.
9.
10. Injector Pump – Provides fuel to the fuel injectors.
11. Air Filter – Prevents dirt and other debris from entering the
12. Thermostat
13. Oil Filler Cap – Remove to add engine oil.
14. Starter – Starts engine when ignition key is rotated to the
15. Alternator
16. Oil Pan
Oil Drain Plugs (2) – Remove to drain crankcase oil.
Always dispose of used oil and oil filters in an
environmentally safe manner. DO NOT allow used oil to
drain onto the ground or into a water runoff drain.
Fuel Filter – Filters fuel for contaminants.
Oil Filter – Spin-on type, filters oil for contaminants.
Oil Dip Stick – Remove to check amount and condition of
oil in crankcase.
fuel system. Unsnap air filter cover to gain access to filter
element.
"ON" position.
Advertisement
Table of Contents
