Assembly And Installation - MULTIQUIP Whiteman J36H55 Operation And Parts Manual

Assembly and Installation

Before the trowel can be put into operation there are some
components that must be installed before the trowel can be used.
This section provided general instructions on how to install those
components. Instruction sheet P/N 20485 provides further details
for the handle assembly.
Handle Tube Installation (All Models)
Install the handle tube to the gearbox as shown in (Figure 5).
1.
The mounting hardware should be contained in the shipping
container.
1
4
Main Handle (Tube)
1
Gearbox
2
3 3/8" Hex Nut
3/8" Hex Head Screw
4
Figure 5. Handle Tube Installation
Pivot the T-handle back (full pitch) (Figure 6). This will
2.
relax the spring inside the handle tube. Spread the handle
bar ends just enough to engage the teeth on the handle
tube. Attach the hand wheel assembly, position handlebar
to desired location, and tighten hand wheel firmly.
CAUTION
The Quick-Pitch™ handle is spring loaded, personal injury
or damage could result from improper handling or
installation. Be careful when installing this component.
J36/M30 WALK-BEHIND TROWEL — OPERATION AND PARTS MANUAL — REV. #10 (05/07/12) — PAGE 19
5
3
2
ASSEMBLY AND INSTALLATION
NOTICE
Considerable force may be required when moving the
Quick-Pitch ™ T-handle forward or backward.
2
HEX SCREW 3/8-16 x 5
PIVOT PITCH HANDLE
1
BACK AS SHOWN TO
RELIEVE SPRING TENSION
(QUICK PITCH MODEL)
5
SPREAD
SLIGHTLY
TO INSTALL
Pivot Pitch Handle (Pivot back to
1
relieve spring tension)
2 Hex Screw (3/8 - 16 x 5)
Full Pitch
3
No Pitch
4
Spread Slightly to Install
5
6 Hand Wheel
Figure 6. Handlebar Installation
Throttle Cable Installation
1. Uncoil the throttle cable and housing.
2. Feed the throttle cable through the cable housing.
3. Connect the throttle cable to the engine. (Figure 7), HONDA
and (Figure 8), ROBIN. There should be a piece of wire
installed on the trowel to show where to route the throttle
cable. Route cable end (item 2) through the spring (item 4)
and swivel stop (item 6). When connecting the cable housing,
make sure that no more than 1/4" (6.4mm) of the cable
housing (item 5) protrudes past the housing clamp (item 7)
on the engine.
3
FULL
4
PITCH
NO
PITCH
6
HAND WHEEL