MULTIQUIP Whiteman J36H55 Operation And Parts Manual page 21

3
Operator Presence Wiring (Option)
1
Operator Presence Lever (Option)
2
(Temporary Positioning for Shipping)
3 Tail Wire From Engine
Safety Stop Wire From Switch
4
Safety Stop Switch
5
Throttle Lever
6
Figure 10. Safety Wire Connection
3. Install the ground wire to the engine, (Honda engine shown,
Figure 11).
Ground Wire
from handle
Figure 11. Ground Wire Connection
4. If so equipped, reposition the Operator Presence Lever on
the handlebars, (Figure 12).
Figure 12. Repositioning the Lever
J36/M30 WALK-BEHIND TROWEL — OPERATION AND PARTS MANUAL — REV. #10 (05/07/12) — PAGE 21
1
2
4
6
5
ASSEMBLY AND INSTALLATION
5. Remove one 7mm nut from each of the terminals on the
Safety Stop Switch. (Leave the existing two wires to the
switch connected.) (Figure 13).
Figure 13. Safety Stop Switch Connection
6. Connect the two wires from the Operator Presence Lever
to the Safety Stop Switch terminal lugs. (one per lug; either
position). Reinstall and tighten the nuts. (Figure 14).
Figure 14. Wiring Connection
Pitch Cable Installation
1. Expose the pitch cable to maximum by adjusting the handle
pitch to the "no pitch" position. Pivot the pitch handle forward
or no pitch, (Figure 15).
NO PITCH
FORWARD
Figure 15. "No Pitch" Position