MULTIQUIP Whiteman J36H55 Operation And Parts Manual page 26

Starting the Engine ( HONDA engine)
1. Place the engine fuel valve lever (Figure 24) to the "ON"
position.
Figure 24. Engine Fuel Valve Lever
3. Place the centrifugal "kill" switch (Figure 25) in the "ON"
position. For models that use this feature.
CAUTION
NEVER disable or disconnect the centrifugal kill switch. It is
provided for the operators' safety and injury may result if it is
disabled, disconnected or improperly maintained.
OFF
ON
Figure 25. Centrifugal "Kill" Switch
PAGE 26 — J36/M30 WALK-BEHIND TROWEL — OPERATION AND PARTS MANUAL — REV. #10 (05/07/12)
"KILL" SWITCH
(SAFETY-STOP)
4. Place the Choke Lever (Figure 26) in the " OPEN " position
Figure 26. Engine Choke Lever
5. Grasp the starter grip (Figure 27) and slowly pull it out. The
resistance becomes the hardest at a certain position, corre-
sponding to the compression point. Pull the starter grip briskly
and smoothly for starting.
Figure 27. Starter Grip
6. If the engine has started, slowly return the choke lever
(Figure 26) to the CLOSED position. If the engine has not
started repeat steps 1 through 5.
7. Before the trowel is placed into operation, run the engine for
several minutes. Check for fuel leaks, and noises that would
associate with a loose guard ring and/or covers.
OPERATION