MULTIQUIP Whiteman J36H55 Operation And Parts Manual page 20

1
8
Adjuster Nut
1
2 Cable End
Swivel Stop
3
Idle Return Spring
4
Cable Housing (End)
5
6 Swivel Stop Hole
7 Cable Housing Clamp
Clamp Screw
8
Figure 7. Throttle Cable Connection (HONDA)
1
Throttle Cable
1
2 Engine Throttle Lever
Place Throttle Cable Here
3
1/4" (6.4mm) Deflection
4
Figure 8. Throttle Cable Connection (ROBIN)
4. Tighten cable clamp screw (item 8) and swivel stop screw
(item 3).
5. After the cable has been installed on the engine, adjust
and tighten operator position of the handle to lock the
throttle cable at the proper length.
6. Adjust cable tension. Loosen the lock nut on the throttle
cable receiver (Figure 9) and loosen or tighten the nut
below it. Retighten the lock nut.
PAGE 20 — J36/M30 WALK-BEHIND TROWEL — OPERATION AND PARTS MANUAL — REV. #10 (05/07/12)
2
3
4
5
7
2
3
4
ASSEMBLY AND INSTALLATION
NOTICE
If the throttle lever does not return to the "neutral"
position with throttle backed off, loosen adjuster nut
(item 1) 1/2 turn at a time, tighten and recheck. Readjust
throttle tension as necessary.
7. These are general instructions. Installation of the throttle
6
cable may vary for different engine configurations. Please
look for more detailed instructions inside the box containing
the handle. These more detailed instructions should provide
adequate guidance for installing.
1
2
Figure 9. Safety Wire Connection
Handle Height Adjustment
If handle height adjustment is desired, a handle wedge kit can be
purchased for your trowel by ordering P/N 2576 from your Multiquip
dealer. These wedges are placed between the handle and the
gearbox to adjust the operating height of the handle. This kit
comes complete with wedges, new bolts and installation
instructions. This will move your operating handle position up or
down approximately 3" (76mm).
Operator Presence Switch Installation (Optional)
Your adjustable handle utilizes an "Operator Presence Switch"
that shuts the engine down once the Operator Presence Lever
is released. To install the lever, switch, and associated wiring,
perform the following procedures:
1. Ensure the handle tube is properly installed onto the
gearbox, handlebars onto the handle tube, and throttle
cable installed according to the instruction sheet provided
with the handle.
2. Connect the Safety Stop Wire from the Safety Stop Switch
to the tail wire on the engine. (Figure 10)
2
1
Adjusting Nut
Locking Nut