Tips For Solving Problems - Panasonic DP-C406 Operating Instructions Manual

9Solving Problems

Tips for Solving Problems

If you encounter the problems, please check following items.
Problem
While sending A document does not feed, or
multiple pages are fed at the
same time.
Does not stamp.
The verification stamp image
appears too light.
Vertical lines appear in a
transmitted document.
Document is transmitted as
blank paper.
Document is misfeeding.
While receiving Paper out
Paper jam
Paper does not feed.
Paper is not exited at the end
of a print job.
The Automatic Print
Reduction feature does not
work.
214
Symptom
• Check that the document does not have staples
or clips attached to it and that it is not smeared
or broken.
• Check if the document is loaded properly.
Verify the settings of the Function Parameters "04
Stamp (HOME)" (Fax/Email Settings > Fax
Parameters) and "28 Stamp at Memory XMT".
Replace the verification stamp.
Make a copy on this machine and check the image
quality. If the copy is OK, notify the receiving
station at fault.
If there are any problems with the copy, clean the
document scanning surface area.
• Check if the document is loaded properly.
• Make a copy on this machine and check image
quality. If the copy is OK, notify the receiving
station at fault.
If there are any problems with the copy, clean
the document scanning surface area.
1. Remove the jammed document according to the
error code displayed on the Touch Panel Display.
2. The machine cannot send overlong document.
Confirm the document length according to the
guidelines shown below.
• Document length exceeds 2 meters in "Std" and
"Fine" mode.
• Document length exceeds 1.38 meters in "S-
Fine" and "600dpi" mode.
An error massage will appear on the display if the
machine has run out of the paper while receiving a
document. Load paper.
If paper jam occurs, an error code is displayed.
Remove the jammed paper.
Check if the Paper Tray is loaded with paper. Load
paper as directed by relevant instructions.
Check if the paper has jammed in the machine.
Check the setting of the Function Parameter "24
Print Reduction" (Fax/Email Settings > Fax
Parameters).
Action Refer to
Operating
Instructions (For
Function
Parameters)
Replacing the
Verification
Stamp (see page
223)
Operating
Instructions (For
Maintenance)
Operating
Instructions (For
Maintenance)
Operating
Instructions (For
Maintenance)
Operating
Instructions (For
Maintenance)
Operating
Instructions (For
Function
Parameters)