Kenwood LSF-1010 Instruction Manual page 22

22
3. Attach and fasten the arm.
You may now want to readjust the angle of the speaker on the arm. You can do
this by loosening the screw holding the speaker to the arm, repositioning the
screw, and then retightening it. See "Adjusting the Speaker Angle, " on page 8.
4. Connect the satellite speaker to the base of the stand using separately pur-
chased extension speaker cord.
• Use cord that has a mini-plug (3.5-mm) at one end and a mini-jack (3.5-mm) on
the other. Do not connect the wire from the speaker directly to an amp; the
connection must be relayed through the base.
Extension speaker cord
1 Fit the arm through the holes in the arm
holders, adjust it to the desire height,
and then tighten the arm screws.
2 Place the screw caps back over the arm
screws.
Other Ways to Set Up the Satellite Speakers
LSF-1010 (EN)