Kenwood LSF-1010 Instruction Manual page 21

Clip-on Mount
Use the following procedure to clip the speaker onto an object other than the
base. You can clip to either a cylindrical fixture (such as a thin pipe) or a flat-edge
fixture (such as the edge of a bookshelf).
Conditions
If flat: Width should be 12 to 15 mm (about 0.5 to 0. 6 inches)
If cylindrical: Diameter should be 12 to 20 mm (about 0.5 to 0.8 inches).
Other Ways to Set Up the Satellite Speakers
For information about how to remove/replace the screw caps and loosen the arm
screws, see page 16, "Getting Ready to Adjust."
1. Remove the arm.
Loosen the screws.
2. Clamp the clip onto an appropriate object.
LSF-1010 (EN)
1 Loosen the two arm screws and pull
the arm out.
• Unplug the cord from the jack before
removing the arm.
• If you want to change the angle of the
arm, set the arm holders to the appro-
priate angle. For instructions, see
page 17, "Adjusting the Arm Angle."
1 Unclamp the clip from the stand, and
clamp it onto an appropriate flat edge
or cylinder.
• If clipping to a flat edge, set so that the
entire rubber part of the clip makes
contact with the flat surface.
• If clipping to a cylinder, set so that the
rubber part fits (curves) around the
cylinder.
2 Gently push the clip up, down, right,
and left to confirm that it is securely
fixed in place and maintains its posi-
tion. Many objects are not suitable as
supports — either because the mate-
rial is not strong enough or because
the surface does not allow an adequate
grip. Do not clip to any object that does
not offer sufficient stability.
(To be continued.)
21