Kenwood LSF-1010 Instruction Manual page 17

Adjusting the Arm Angle
You can set the arm to any of five different angles by adjusting the angle of the
arm holders.
1. Remove the arm.
Remove the arm.
Loosen the screws.
Arm holders
Remove the screws from the arm holders.
1 Loosen the two arm screws (one screw
on each side of the arm) and pull the arm
out.
• Unplug the cord from the jack before
removing the arm.
2 Loosen the two arm screws further to re-
move them from the arm holders.
Adjusting the Satellite Speaker Position
2. Set the arm holders to the desired angle.
At time of shipping, the arm is
mounted at angle D.
3. Insert and fasten the arm.
You may now want to readjust the angle of the speaker on the arm. You can do
this by loosening the screw holding the speaker to the arm, repositioning the
screw, and then retightening it. See "Adjusting the Speaker Angle, " on page 8.
LSF-1010 (EN)
1 Take one of the arm holders, rotate it any
of the angles A to E indicated at left, and
place it back into the opening such that
the corners of the arm holder match the
ridges on the opening.
• Please do not set the arm holders to any
angle other than A to E. The speaker may
not be stable (and is likely to tip over) if
mounted at an angle outside of this range.
2 Loosely fasten the holder in place with the
arm screw.
• Don't tighten the screw all the way.
Tighten only enough so that the arm holder
stays in position at the selected angle.
3 Now set the other arm holder (the holder
on the other side) to the same angle, and
loosely fasten it with the arm screw.
1 Fit the arm through the openings in the
arm holders and adjust to the desired
height. Then tighten the two arm screws
to lock the arm in place.
2 Replace the screw caps.
3 Reconnect the speaker cord to the jack.
17