16
Adjusting the Satellite Speaker Position
You can adjust the position of the speaker by changing the height and angle of
the arm.
Adjusting the arm height
Getting Ready to Adjust
Loosen the two arm screws holding the arm in place (one screw on each side of
the arm), so that you can move the arm up and down.
1. Remove the screw cap covering each arm screw.
Screw
caps
Adjusting the arm angle
To remove each cap, grasp it at the cir-
cumference and peel it off.
To replace the cap, place it over the screw
head and lightly press it along the circum-
ference.
2. Loosen the two screws.
Screw
Use a coin to turn the screws
(one screw on each side).
Adjusting the Arm Height
Move the arm up or down to raise or lower the speaker.
1. Loosen the two arm screws as described above, so that the arm can move up
and down.
2. Raise or lower the arm to the desired height, then retighten the two screws.
Move arm up or down to
desired position.
3. Replace the screw caps.
You may now want to readjust the angle of the speaker on the arm. You can do this
by loosening the screw holding the speaker to the arm, repositioning the screw, and
then retightening it. See "Adjusting the Speaker Angle," on page 8.
LSF-1010 (EN)
Use a coin to turn each screw.
• Once you have loosened both screws you
will be able to move the arm up and down,
or to remove it entirely.
Use a coin to retighten
the screws.