Kenwood LSF-1010 Instruction Manual page 12

12
Connecting to Amp's Speaker Output Terminals
Connect the FROM AMPLIFIER terminals on the subwoofer to the
speaker output terminals on your amplifier or receiver. Connect the
TO SPEAKERS terminals on the subwoofer to your front speakers. Make
all connections using speaker cord.
Speaker cord for the connection between the amp and the subwoofer is not included. Please
purchase this cord separately.
SPEAKERS
R
Speaker output terminals (on amp or receiver)
IMPORTANT
The satellite speakers have a nominal impedance of 6
ohms. Be sure that your amplifier or receiver is able to
work with 6-ohm speakers.
If your amplifier or receiver has two sets of speaker output terminals, you can connect the front speakers directly to the second set of terminals (rather than connecting
Note Note them to the TO SPEAKER terminals on the subwoofer).
L
Subwoofer
Speaker cord
(purchased separately)
ª · ª
Speaker cord (included)
· ª
Satellite speakers
(right)
CAUTION
Do not plug in the power cord until you have finished mak-
ing all connections.
Included speaker cord
·
1
2
· ª
3
4
(left)
Making Connections
LSF-1010 (EN)
White stripe
Twist the wire.