Kenwood LSF-1010 Instruction Manual page 13

Connecting to Amp's Standard PRE-OUT Jacks
Connect the PRE-OUT jacks on the amp or receiver to the LINE IN jacks
on the subwoofer. Make the connection using pin-plug audio cable.
(The cable is not included with the subwoofer.)
PRE OUT
PRE-OUT jacks (on amp or receiver)
· · ª ª
(right)
Included speaker cord
Pin-plug audio cable (purchased separately)
SPEAKERS
R L
L
R
Speaker cords (included)
· ·
Satellite speakers
(left)
White stripe
Do not plug in the power cord until you have finished mak-
ing all connections.
Note About Pin-Plug Cables
Some commercially available pin-plug cables have relatively plug ends that
may become bent if the subwoofer is installed vertically. Bending of plugs
may cause internal wires to break, resulting in loss of sound. If installing the
ª ª
subwoofer vertically, be sure to use pin-plug cables with short plugs.
• It is also possible to connect the subwoofer's LINE IN jacks to the REC OUT
Notes Notes Notes
or LINE OUT jacks on the amp or receiver (using the same cable as described
here). If you make this type of connection, however, volume adjustments at
the amp side will not affect the volume from the subwoofer. This means that
you will need to manually adjust the subwoofer volume each time you adjust
the volume at the amp side.
• If you wish to connect the subwoofer to the PRE-OUT jacks on a standalone
preamplifier, the preamp unit must include a second set of terminals for
connection to speaker amps, and must be capable of simultaneous output to
both the PRE-OUT jacks and the speaker-amp jacks.
Making Connections
CAUTION
Subwoofer
13
LSF-1010 (EN)