Speaker Setup; [Speaker Select] - Kenwood DDX6046BT Instruction Manual

Speaker Setup

You can select a speaker type and its size to get
the best sound effects.
1 Display the Speaker Select screen
>
Touch [ ] [
[Speaker Select]. (page 62)
2 Select a speaker you wish to adjust
When the speaker type and size are set, the
speaker crossover network and equalizer curve
are set automatically.
1
2
3
Front speaker
1
Rear speaker
2
Subwoofer
3
[Subwoofer] Sets the availability of
subwoofers.
[X'over] Displays the Speaker Crossover Setup
screen.
You can adjust the crossover setup that was
set automatically when you selected the
speaker type.
3 Select a speaker type
You can select front speaker type.
"Standard"/ "Wide"/ "Middle"/ "Narrow"
⁄
• Speaker cannot be setup when in STANDBY source
mode.
DDX SERIES DDX616/DDX6046BT/DDX516
> >
] [Audio SETUP]
Crossover Network Setup
You can set a crossover frequency of speakers.
1 Select the speaker to set the crossover
1 1 1
2 2 2
3 3 3
1 Sets the High Pass Filter of the front speaker.
2 Sets the High Pass Filter of the rear speaker.
3 Sets the Low Pass Filter of the sub woofer.
2 Display the Crossover setup screen
3 Set the crossover
[Phase] Sets the phase of subwoofer output.
The phase is reversed 180 degrees when set
to "Reverse".
Sets the subwoofer phase. (Only when
"Subwoofer" is set to "ON" in Speaker Setup,
and [LPF FREQ] is set to other than "Through")
[HPF FREQ] High Pass Filter adjustment.
(When front or rear speaker is selected on
Speaker Select screen)
[LPF FREQ] Low Pass Filter adjustment. (Only
when "Subwoofer" is set to "ON" in Speaker
Setup)
English 75