Equalizer Control; Tone Setup - Kenwood DDX6046BT Instruction Manual

Audio Control

Equalizer Control

You can set up the equalizer.
1 Display the Equalizer screen
>
Touch [ ] [
2 Set each item
[SystemQ] Selects an equalizer curve type.
You can select any of the following equalizer
curves.
"Natural"/ "Rock"/ "Pop"/ "Easy"/ "Top40"/
"Jazz"/ "User"
⁄
• "User":
Your own tone curve can be created. See <Tone
Setup> (page 60).
[SystemQ-EX] Selects items to be adjusted for
tone curve setup.
If selected "OFF", only Level can be set up for
tone curves.
[Tone] Displays the Tone curve setup screen.
(page 60)
60 DNX SERIES DNX6960/DNX6160/DNX6020EX/DNX6460BT/DNX5160
>
] [Equalizer]. (page 59)

Tone Setup

You can set a Tone curve.
1 Display the Equalizer screen
> >
Touch [ ] [ ]
2 Display the Tone Control screen
3 Set the Tone
[Bass] Bass adjustment items are displayed.
[Middle] Middle adjustment items are
displayed.
[Treble] Treble adjustment items are displayed.
[Flat] Tone level becomes 0 (flat).
[FREQ] Sets the Center frequency.
[Level] Sets the level.
[Q Factor] Sets the Q factor. (Only [Bass] and
[Middle] can be set)
[Bass DC EXT] Bass DC Extend settings. (Only
[Bass] can be set)
If turned "ON", it extends the bass center
frequency to the low register by approximately
20%.
[SW Level] Adjusts the subwoofer volume.
The setting is available when subwoofer is set
to "ON". See <Speaker Setup> (page 75).
[Equalizer]. (page 59)