Table of Contents
Advertisement
BASIC SETUP
EN
The Setup Wizard
Starting the DVR for the first time:
When you first boot the DVR, it will automatically start "The
Setup Wizard" which will guide you through the various
setup options available. The wizard contains six quick setup
screens which will allow you to choose how you want the
DVR to behave. Please be patient as it can take up to 40
seconds for the wizard to appear after the DVR is turned
on.
You'll be asked to:
•
Select a language.
•
Set a password for the ADMIN account.
•
Configure the time, date and time zone for your location.
•
Configure the DVR so it can operate on your network
and access (and be accessed from) the Internet.
•
Initialize and format your hard drive(s), if required.
Setup Wizard: Language
System Language: Select the language you'd like the menu
system to be displayed in.
Setup Wizard: Wizard
When this checkbox is left ticked, the setup wizard will run
again the next time the DVR is rebooted or powered on. If
you don't want the wizard to start the next time the DVR is
turned on, uncheck this box.
To access the wizard after it's been disabled, open Main
Menu > Configuration > General and select Enable Wizard.
13
13
Advertisement
Table of Contents
