Table of Contents
Advertisement
ADVANCED CONFIGURATION
EN
Motion Detection Area Configuration
Setting the MOTION DETECTION AREA
In the MOTION DETECTION menu, select the AREA SETUP
(shown above) for the channel you wish to setup the
MOTION DETECTION AREA for.
You will see a grid of red boxes. The outlined boxes
•
mark the area that is sensitive to motion. The area
without the red outlines is not sensitive to motion.
•
Use the mouse to move the cursor around the screen.
•
By left clicking an area in the grid, you can toggle
motion detection ON or OFF in that location.
•
Click and drag to select the area you want to select or
de-select.
In the sample image above, a person entering the room
through the window would trigger the motion detection.
However, a person entering from the right of screen should
avoid the motion sensitive area. This is a good solution to
monitor the windows (left of image) without getting false
triggers every time someone enters the room from the
right.
Sensitivity: The Sensitivity setting is controlled by a slider,
allowing you to set a value between L (low) and H (high).
The closer to H the slider is set, the more sensitive the
motion detection will be.
Full Screen: Will select the entire area for motion detection.
Clear: Will clear the entire area.
Get an able-bodied volunteer to move about in front of
the cameras you'd like to tune the sensitivity for. The ideal
sensitivity level is when your volunteer moving about
always triggers the motion detection, but there are no false
triggers (or very few) when your volunteer isn't moving
about.
49
49
Advertisement
Table of Contents
