Installation Of Indoor Unit - Toshiba RAV-SM564CT-E Installation Manual

Ceiling Type
Before installation
1
Removal of air intake grille
Remove the screws of air intake grille fixing knob
on a side of each filter.
Slide the air intake grille fixing knobs (two
positions) toward the arrow direction, and then
open the air intake grille.
Under the condition of air intake grille opened,
push the hook section of hinges (two positions) at
the rear side, and then pull out the air intake grille.
Pull out air intake grille
while pushing hook.
Hinge
Air intake grille Air intake
fixing knob grille
2
Removal of side panel
After removing the side panel fixing screws (1
each at right and left), slide the side panel forward
and then remove it.
Protector
Side panel
Level louver
Slide forward.
3
Removal of protective vinyl
Peel out the protective vinyl on the level louver.
4
Removal of protector
Remove the protectors (2 pcs.) of the fan.
(RAV-SM804CT only)
13-EN
Installation Manual
Draw-out direction of pipe /
wire
Decide installation place of the unit and draw-out
direction of pipe and wire.
Pipe knockout hole
In case of taking pipe from the rear side
* Cut off the groove section with a plastic cutter.
Rear cover
100
Opened when refrigerant pipe
is taken out from the rear side
Grooves
Opened when only drain pipe
is taken out from the rear side
In case of taking pipe from right side
* Cut off the groove section with a metal saw or plastic
cutter.
Groove
Side panel (Right)
Ceiling Type
– 7 –
In case of taking pipe from left side
Taking pipe from left side is applied only to the
drain pipe.
The refrigerant pipe cannot be taken out from the
left side.
* Cut off the groove section with a metal saw or plastic
cutter.
Groove Side panel (Left side)
In case of taking pipe from upper side
Taking pipe from upper side is applied only to the
refrigerant pipe.
When taking out the drain pipe from the upper side,
use a drain up kit sold separately.
Open the upper pipe draw-out port (Knockout hole)
shown in the external view.
(Knockout hole of metal plate)
After piping, cut off the attached heat insulator of the
top plate to pipe shape, and then seal the knockout
hole.
Knockout hole of power wire
take-in port
Open the power wire take-in port (Knockout hole)
shown in the external view and then mount the
attached bushing.
Installation Manual

Installation of indoor unit

Preparation before holding down main unit
* Confirm the presence of the ceiling material
beforehand because the fixing method of hanging
metal when the ceiling material is set differs from that
when the ceiling material is not set.
<There is ceiling material>
Hanging bolt
(Procured locally)
Ceiling surface
Indoor
unit
Washer (Accessory)
Double nut
(Procured locally)
Hanging
metal
Nut
Hanging bolt
(Procured locally)
(Procured locally)
Ceiling surface
Indoor
unit
Washer (Accessory)
Double nut
(Procured locally)
Hanging
metal
* Tighten the hanging metal with upper / lower nuts as
shown in the figure.
14-EN