Audio Control Setting - Kenwood KDC-8080R Instruction Manual

NOTE
If the faceplate bracket's angle was not set to the vertical when
the faceplate was mounted, check that the faceplate is securely
attached to the faceplate bracket by holding its right side and
pulling it gently towards you.

Audio Control Setting

Adjust various parameters of sound quality.
1
Press the AUD button to enter the control mode.
2
Selecting mode
Press either the FM or AM button.
Each time the button is pressed, the adjustment mode will
change.
Please refer to the following for the contents of the
adjustment modes.
NOTE
Source tone memory
Each source (CD, FM, AM, and disc changer) has its own
memory in which to store the bass, treble and N-F level settings.
The settings made for a particular source are then recalled
automatically whenever you use that source (e.g., FM mode uses
the tone settings made for FM, AM for AM, etc.).
3
Adjust each mode
Press the 4/¢ button.
Look at the table to adjust the mode being displayed.
4
Press the AUD button to end the control mode.
"dB" : Recalling the kenwood preset sound setting
Press the preset buttons (#1-6).
Settings: #1;Flat, #2;Rock, #3;Pops, #4;Jazz, #5;Easy,
#6;Scan of #1-5
NOTE
• This mode is available only when the Sound coordinate system
is on. (page 36)
• You can call the following settings with this function; bass
centre frequency, bass level, bass quality factor, bass
extension, treble centre frequency, and treble level setting.
Their setting values are different depending on the setting of
the mobile preset plan mode.
"Bass Frq" : Adjust the centre frequency of the bass.
Setting values: 60 / 70 / 80 / 100 (Only when the bass quality
factor is set to 1.00, 1.25 or 1.50) / 150 (Only when the bass
quality factor is set to 2.00) Hz
NOTE
This mode is available only when the Sound coordinate system is
on. (page 36)
"Bass" : Adjust the bass level.
Setting values: - 8 – + 8
"Bass Q" : Adjust the Bass quality factor.
Setting values: 1.00 / 1.25 / 1.50 / 2.00
NOTE
This mode is available only when the Sound coordinate system is
on. (page 36)
— 13 —