Other Features; Audio Control Setting; Clock Display; Adjusting Time - Kenwood KDC-4060RG Instruction Manual

Other features

(See page 8)
A udio Cont rol Set t ing
Adjust various parameters of sound quality.
1
Press the AUD button to enter the control mode.
Each time the AUD button is pressed, the adjustment mode
display changes as follow s:
7 Bass 7 Treble 7 Balance 7 Fader 7 Volume
If you do not move to step 2 in 5 seconds, the unit w ill sw itch
back to the volume adjustment mode (i.e., the normal mode).
N OTE
Source tone memory
Each source (CD, FM , and AM ) has its ow n memory in w hich to
store the bass and treble tone settings.
The settings made for a particular source are then recalled
automatically w henever you use that source (e.g., FM mode uses
the tone settings made for FM , AM for AM , etc.).
2
Press the d / u buttons to adjust the mode show n in the
display.
Use the follow ing table as a guide for adjusting the settings in
each mode.
Adjustment
Operation of Audio control button
mode
d button
(Display)
Bass
Bass decreased.
(" BAS" )
Treble
Treble decreased.
(" TRE" )
Balance Left channel
(" BAL" ) emphasized.
Fader Rear channel
(" FAD" ) increased.
Display the time.
Sw itching to Time Display:
When the RDS station tuned into is transmitting a time signal,
have the unit's built-in time adjust automatically to the
correct local time.
Adjusting the Time:
u button
Bass increased.
Treble increased.
Right channel
emphasized.
Front channel
increased.
— 20 —
Clock D isplay
Press the CLK button repeatedly until the clock is displayed.
A djust ing Tim e
Tune into an RDS station for 3 or 4 minutes.
The time adjusts automatically to the correct local time.
N OTE
• The displayed time cannot be set manually, but only through
RDS station time signals.
• The time is not adjusted w hen the RDS station you are tuned to
is not transmitting a time signal. Choose another RDS station in
such a case.