Table of Contents
Advertisement
English
Other features (See page 10)
Audio Control Setting
Adjust various parameters of sound quality.
1 Press the AUD button to enter the control mode.
Each time the AUD button is pressed, the adjustment mode
display changes as follows:
Bers
NON FAD On/Off (only when being switched
Treble
to non-fading preout)
¥
a
Bal
ales
N-F Level(only when being switched to
Fader
i
non-fading preout)
If you do not move to step 2 in five seconds, the control mode
is automatically canceled.
NOTE | Source tone memory
Each source (tape, FM, AM, CD and disc changer} has its own
memory in which to store the bass and treble tone settings.
The settings made for a particular source are recalled
automatically whenever you use that source (for example, FM
mode uses the tone settings made for FM, AM for AM, etc.).
2 Press the \"// buttons to adjust the mode shown in the
display.
Use the following table as a guide for adjusting the settings in
each mode.
Adjustment
Operation of Audio control button
mode
Disply) [| _vbutton
[A button
("Bass")
Treble
Treble
decreased
Treble increased.
{"Treble")
remle
;
Balance
Left channel
Right channel
("Balance"}
emphasized.
emphasized.
Fader
Rear channel
Front channel
("Fader")
increased.
increased.
Non-Fading
Preout Level
("N-F"}
Bass decreased.
Front and rear
_
channels (including
preout) emphasized.
Non-fading sound
emphasized.
Non-Fading
Output
On/Off
("NON FAD")
You can set the non-fading sound output to
either on or off.
"NON FAD On" (ON) © "NON FAD Off' (OFF)
Switching Preout
Switch the preout between the rear and non-fading. The
factory default is rear preout.
Switching the Preout:
1 Press the SRC button repeatedly and switch the display to
"ALL OFF" to enter the standby mode.
2 Press the FNC button for at least one second.
"Function Set" is displayed and the function set mode is turned
on.
= OR
Advertisement
Table of Contents
