Zone2 Setup / Zone3 Setup - Denon AVR-X7200W Owner's Manual

Contents Connections

ZONE2 Setup / ZONE3 Setup

Makes settings for audio playback with ZONE2 and ZONE3.
Values set for "Volume Limit" and "Power On Volume" are displayed according to the
setting specified for the volume "Scale". (v p. 184)
o Bass
Adjust bass.
-10 dB – +10 dB (Default : 0 dB)
o Treble
Adjust treble.
-10 dB – +10 dB (Default : 0 dB)
o High Pass Filter
Make settings for cutting the low range to reduce distortion in the bass.
On: The low range is attenuated.
Off
The low range is not attenuated.
(Default):
Front panel Display
Playback Settings
o Lch Level
Adjust the left channel output level.
-12 dB – +12 dB (Default : 0 dB)
o Rch Level
Adjust the right channel output level.
-12 dB – +12 dB (Default : 0 dB)
o Channel
Set whether to playback in stereo or monaural.
Stereo
(Default):
Mono:
o HDMI Audio (ZONE2 only)
Selects the audio signal format for playing an HDMI source in ZONE2.
Through
(Default):
PCM:
Rear panel 260
Tips
Stereo playback.
Monaural playback.
The HDMI audio signal is passed through this unit to the
device in ZONE2.
The HDMI audio signal input into this unit is converted to a
PCM signal that can be output from the ZONE2 PRE OUT
terminals or speaker terminals.
Remote Index
Appendix