Table of Contents
Advertisement
5.3 Video Search
Click pop-up menu video search to open the "Video Search" menu to search for files and
playback recordings.
5.4 PTZ Control
5.4.1 Cruise Setup
Open auto cruise function on PTZ setting menu if you want to setup cruise function (system
default: on), and set up cruise channel, cur point, total quantity and stop time etc.
SET: save the preset point. After setting channel and setting the position by adjusting PTZ direction
key you click "SET" to setup the pre-set point. Please note you will need to click the "Save" button to
finish the setting successfully. If you want to combine Zoom, Iris, Focus and direction keys into the
pre-set setting, please return to previous menu to add additional settings, and then enter into Cruise
Setup again and click "SET" and "SAVE" to make sure your setting is setup successfully.
CLEAN: remove settings.
Note: this DVR model supports up to 100 pre-set points. But actual quantities may be restricted by
the PTZ camera you are using.
5.5 Manual Record
When you want the system to start recording, click the "REC" button to start manual recording.
5.6 Stop recording
If you want to stop manual recording, click "STOP" on the control menu or the "STOP" button.
Click pop-up menu to show the PTZ option and open the PTZ
control interface. You can now click Z+ & Z- keys to zoom In or
out, click F+ & F- keys to control camera focus and click I+ & I- to
adjust the focus point.
Channel select: select the channel with the PTZ camera
TOTAL: set up presetting bit (angle) quantity. Please refer to
your camera's manual for detail
CUR POINT: System has default starting (current) cruise point
as 01. You can use this option to set additional cruise points.
STOP TIME: sets the pause time at each cruise point.
GOTO!select this option to go to specific preset points
34
User's Manual
Advertisement
Table of Contents
