Group - Uniden OCEANUS DSC Series Owner's Manual

OCEANUS DSC/ATIS_ENG_0512
3. Select the individual you want to contact
using CH L and M. Press SELECT to
transmit the individual DSC signal.
4.
WAITING
individual you have selected, and the
radio use 70 CH while transmitting.
5. When you receive the individual
acknowledgment successfully,
WAITING
Both radios tune to the selected
channel. You are now ready to transmit
on that channel.
Note: If there is not any data registered in the directory you cannot
proceed to the 2nd step. See the SETUP section for directory
setup instructions.
Select an open (unused) working channel first, then make the
call. After the acknowledgment, both radios tune to the
previously selected channel.
1-B. GROUP
1. Press SELECT at
DSC CALL
INDIVIDUAL
Press CH M once to select
2.
5/12/05 10:34 AM
appears followed by the
will change to COMPLETED
(To enter
DSC CALL
, see page 18).
appears.

GROUP

19
Page 19
.
.