G-Analyzer Calibration Setup; G-Analyzer Horsepower Gauge Setup - Kenwood KDC-MP832U Instruction Manual

4
Reset the value
Press the Control knob for at least 2 seconds.
"Reset OK" is displayed.
5
Exit G-Analyzer Reset mode
Press the [MENU] button.
In Standby mode

G-Analyzer Calibration setup

G-Analyzer requires calibration for horizontal
acceleration and braking.
• To ensure accurate calibration, go through the
following steps at a level place where you can move
the vehicle straight ahead.
1
Park the vehicle in a horizontal location
2
Select G-Analyzer Calibration setup mode
Push the Control knob towards [FM] or [AM].
Select the "G-Calibration" display.
3
Enter G-Analyzer Calibration setup mode
Press the Control knob for at least 1 second.
"Stop" is displayed.
4
Start Calibration of horizontal direction
Press the Control knob.
Once "Move Forward" appears on the display, the
vehicle must be advanced.
5
Start Calibration of straight direction
Start moving the vehicle ahead.
Calibration of straight direction automatically
starts.
When the Calibration is finished, "Calibration OK"
is displayed.
• If you fail to complete the calibration, "No Calibration"
is displayed. In such a case, repeat steps 1 through 6.
6
Exit G-Analyzer Calibration setup mode
Press the [MENU] button.
In Standby mode
G-Analyzer Horsepower Gauge
setup
Enter vehicle class and weight to calculate
horsepower.
1
Select the G-Analyzer Horsepower Gauge
setup mode
Push the Control knob towards [FM] or [AM].
Select the "Hp Gauge Setup" display.
2
Enter G-Analyzer Horsepower Gauge setup
mode
Press the Control knob for at least 1 second.
"Class Select" is displayed.
3
Select vehicle class
Push the Control knob towards [4] or
[¢].
Each time you push the knob, the vehicle class
alternates between the modes shown in the
table below.
Display
"Mid Size"
"Full Size"
"SUV"
"Van/ Mini-Van"
"Pickup Truck"
"Sporty"
"Compact"
4
Enter Weight Input mode
Press the Control knob.
"Weight Input" is displayed.
5
Select the weight numbers
Push the Control knob towards [FM] or [AM].
• The weight input range is between 1000-9999 lbs.
6
Select the digits to enter
Push the Control knob towards [4] or
[¢].
7
Repeat steps 5 and 6, and complete the
weight input.
8
Exit G-Analyzer Horsepower Gauge setup
mode
Press the [MENU] button.
45
|
English