System Q; Audio Control - Kenwood KDC-MP832U Instruction Manual

System Q

Selecting the best sound setting preset for
different types of music.
1
Select the source to adjust
Press the [SRC] button.
2
Select the key function section
Press the [NEXT] button.
Repeatedly press the button until "SYS.Q" is
displayed above the [1] button.
Refer to <Notes on Multi-function Key System>
(page 11).
3
Enter System Q mode
Press the [1] ("SYS.Q") button.
4
Select the Sound type
Push the Control knob towards [4] or
[¢].
Each time you push the knob, the setting
switches as shown below.
Sound setting
User memory
Rock
Pops
Easy
Top 40
Jazz
Natural
• User memory:
The values set on the <Audio Control> (page 13).
• Change each setting value with the <Speaker
Setting> (page 15).
First, select the speaker type with the Speaker setting.
Display
"USER"
"ROCK"
"POPS"
"EASY"
"TOP 40"
"JAZZ"
"NATURAL"

Audio Control

1
Select the source to adjust
Press the [SRC] button.
2
Enter Audio Control mode
Press the [VOL] knob.
3
Select the Basic Audio item to adjust
Press the [VOL] knob.
Each time you press the knob, the item to be
adjusted alternates between the items shown in
the table below.
4
Adjust the Basic Audio item
Turn the [VOL] knob.
Adjustment Item Display
1
Rear Volume * "Rear Volume" 0 — 35
Subwoofer level* 2,3 "Sub-W Level" –15 — +15
4
Bass level* "Bass Level"
Middle level* 4 "Middle Level" –8 — +8
4
Treble level* "Treble Level"
Balance "Balance"
3
Fader* "Fader"
Exit Audio Control mode (Volume control mode)
1
• * You can control this item when "2 ZONE" of <Audio
Setup> (page 14) is set to "ON".
• * 2 You can control this item when <Subwoofer
Output> (page 15) is set to "SW ON".
• * 3 You can control this item when "2 ZONE" of <Audio
Setup> (page 14) is set to "OFF".
4
• * You can adjust these items in detail. Refer to
<Adjusting the detail of Audio Control>(Page14).
(Function of the KDC-X890)
• * 4 Source tone memory: Puts the set up value in the
memory per source. (Detail Audio item is included)
5
Exit Audio Control mode
Press any button.
Press a button other than the [VOL] knob, [ANG]
and [ATT] button.
Range
–8 — +8
–8 — +8
Left 15 — Right 15
Rear 15 — Front 15
13
|
English