Selectable Illumination; Display Illumination Control; Dimmer; Built-In Amp Setting - Kenwood KDC-MP832U Instruction Manual

Menu system
In Standby mode

Selectable Illumination

Selecting the button illumination color as green
or red.
Display Setting
"Button : Red" The illumination color is red.
"Button : Green" The illumination color is green.

Display Illumination Control

This function turns off the display when you
perform no operation for 5 seconds. This function
is effective when you are driving at night.
Display Setting
"Display : ON" Keeps the display on.
Turns off the display when you perform no
"Display : OFF"
operation for 5 seconds.
• Set the Display Illumination Control when the
<Demonstration mode Setting> (page 54) is set to
OFF.
• When the display is off, pressing any key will turn on
the display.
• When the display is off, you cannot perform any
operation except for the following:
• Volume
• Attenuator
• Selecting the source
• Ejecting the disc
• Faceplate Angle Adjustment
• Turning off the power
• During function control, such as the Menu System, the
display stays on.
In Standby mode

Dimmer

Dimming this unit's display automatically when
the vehicle light switch is turned ON.
Display Setting
"Dimmer : ON" The display dims.
"Dimmer : OFF" The display doesn't dim.
44
|
English
In Standby mode

Built-in Amp Setting

Controlling the built-in amplifier.
Turning OFF this control enhances the preout
quality.
Display Setting
"AMP : ON" The built-in amplifier activates.
"AMP : OFF" The built-in amplifier deactivates.
In Standby mode

G-Counter Level set

Calibrating G-Point. Setting the level according to
the kinds of vehicles.
Display Setting
"G-Counter : Level1" Counter is easy to go up.
"G-Counter : Level2"
"G-Counter : Level3" Counter is hard to go up.
• In the case of driving situations calling for few
accelerations, set the G-Point up to "G-Counter :
Level1". In the case of frequent accelerations, set it up
to "G-Counter : Level3".
In Standby mode

G-Analyzer Reset

Resets the value of G-Meter, G-Counter and G-
Analyzer Horsepower Analysis.
1
Select G-Analyzer Reset mode
Push the Control knob towards [FM] or [AM].
Select the "G-Reset" display.
2
Enter G-Analyzer Reset mode
Press the Control knob for at least 1 second.
3
Select the Reset item
Push the Control knob towards [FM] or [AM].
"G-Meter Reset": Reset the value of G-Meter.
"G-Counter Reset": Reset the value of G-Counter.
"G-Power Reset": Reset the value of G-Analyzer
Horsepower Analysis.