G-Analyzer Calibration Setup; G-Analyzer Stop Watch - Kenwood eXcelon KDC-X792 Instruction Manual

In Standby mode

G-Analyzer Calibration Setup

G-Analyzer requires calibration for horizontal
acceleration and braking.
⁄
• To ensure accurate calibration, go through the following
steps at a level place where you can move the vehicle
straight ahead.
1
Park the vehicle in a horizontal location
2
Enter G-Analyzer Calibration setup mode (In
Display Type F)
Select "DISP" > "GMA" > "CAL".
For how to select Function Control item, refer to
<Function Control> (page 6).
"G-CALIBRATION" is displayed.
3
Start Calibration of horizontal direction
Press the Control knob.
Once "Move Forward" appears on the display, the
vehicle must be advanced.
4
Start Calibration of straight direction
Start moving the vehicle ahead.
Calibration of straight direction automatically starts.
When the Calibration is finished, "Calibration OK" is
displayed.
⁄
• If you fail to complete the calibration, "No Calibration" is
displayed. In such a case, repeat steps 1 through 4.
5
Exit G-Analyzer Calibration setup mode
Press the [FNC] button.

G-Analyzer Stop Watch

The control of stop watch can be started by G-
Analyzer function.
¤
• Do not use G-Analyzer stop watch on the Public roads.
1
Enter G-Analyzer Stop Watch mode (In Display
Type F)
Select "DISP" > "GMA" > "STOP.W".
For how to select Function Control item, refer to
<Function Control> (page 6).
"STOP WATCH" is displayed.
2
Make the counter ready
Press the Control knob.
"Ready" is displayed.
3
Start Count
When G in the vertical direction is detected during
the travel, the count automatically starts.
"Running" is displayed.
4
Stop Count
Press the Control knob.
"Stop" is displayed.
When you Reset the Count
(While "Stop" is displayed)
Press the Control knob for at least 1 second.
5
Exit G-Analyzer Stop Watch mode
Press the [FNC] button.
⁄
• Pressing the Control knob in step 3 allows you to start
counting.
• Pressing the Control knob in step 4 allows you to restart
counting.
13
|
English