Table of Contents
Advertisement
Chapter 3:
Configuring the Host Computer
Before you begin, the Internet Protocol (TCP/IP) settings of the host computer must be
configured properly to access the Web-based Configuration Utility. Configurations are as
follows:
IP Address
Subnet Mask
3.1
Windows XP
If you are using Windows
1.
Click Start > Control Panel > Network Connections.
2.
Right-click Local Area Connection (for wired computer) or Wireless Network
Connection (for wireless computer), then click Properties.
3.
On the network components list, make sure that Internet Protocol (TCP/IP) is
checked. If not, check it to enable the Properties button.
4.
Select Internet Protocol (TCP/IP), and then click Properties.
5.
On the General tab, select Use the following IP Address.
6.
Enter the IP Address and Subnet Mask of the Extender.
7.
Click OK.
3.2
Windows Vista
If you are using Windows
below.
1.
Click Start > Control Panel > Network and
Internet Connections > Network
Connections.
2.
Right-click Local Area Connection (for wired
computer) or Wireless Network Connection
(for wireless computer), then click Properties.
3.
On the network components list, make sure that Internet Protocol (TCP/IP) is
checked. If not, check it to enable the Properties button.
: 192.168.10.xxx
(where xxx is a number between 100 ~ 199)
: 255.255.255.0
®
XP, follow the instructions below.
®
Vista, follow the instructions
11
www.encore-usa.com
Hide quick links:
Advertisement
Table of Contents
