Encore N300 User Manual page 34

The availability of some parameters vary depending on the selected WLAN Band.
WLAN Band — Select the type of wireless clients to allow connection with:





If the selected WLAN Band is B, G, or B+G, the following parameters are available:
Available in WLAN Band:
B, G, or B+G only
Available in WLAN Band:
G+N or B+G+N only
TX Rate — Select the basic transfer rate based on the speed of the Extender.
Preamble Type — Preamble type defines the length of CRC (Cyclic Redundancy Check)
block that detects data transmission errors between the access point and the Extender.
Select Short if the network traffic is high.
WMM — Select Enable to enable the WMM (Wi-Fi Multimedia) feature. This prioritizes
multimedia applications over regular data packets, making multimedia applications run
smoother and with fewer errors.
If the selected WLAN Band is B, G, or B+G, the following parameters are available:
Short GI — Select Enable to reduce the guard interval time and increase data capacity.
Channel Width — Select the channel width:


B: Allows 802.11b wireless devices only.
G: Allows 802.11g wireless devices only.
B+G: Allows 802.11b and 802.11g wireless devices only.
G+N: Allows 802.11g and 802.11n wireless devices only.
B+G+N: Allows 802.11b, 802.11g, and 802.11n wireless devices.
20MHz: Select if non-802.11n wireless clients are present in the
network.
20/40MHz: Select if 802.11n and non-802.11n wireless clients are
present in the network.
www.encore-usa.com
33