Configuring The Extender; Configure The Host Computer; Accessing The Web-Based Configuration Utility - Encore N300 Series Quick Installation Manual

Chapter 3:

Configuring the Extender

To configure the Extender, you must configure the host computer first and then access the
web-based configuration utility.
3.1

Configure the Host Computer

Before you begin, the Internet Protocol (TCP/IP) settings of the host computer must be
configured properly to access the Web-based Configuration Utility. Configurations are as
follows:
IP Address
Subnet Mask
Note: See "Chapter 3: Configure the Host Computer" of the User Manual for detailed
configuration information per operating system.
3.2

Accessing the Web-based Configuration Utility

Take note of the following default settings.
: 192.168.10.xxx
(where xxx is a number between 100 ~ 199)
: 255.255.255.0
SSID : default
Channel : 6
Security : Disable
8
www.encore-usa.com