Table of Contents
Advertisement
Installation requirements and recommendations
For best results, follow these requirements and recommendations before installing a WSS.
WLAN Management software network plan
If you are using WLAN Management Software to plan your Nortel WLAN 2300 System installation, Nortel recom-
mends that you create and verify a network plan for the entire Nortel network installation before installing WSSs or APs.
A network plan provides the following information:
•
Number of WSSs required at your site, and where to install them
•
Number of APs required for adequate WLAN capacity in each coverage area, and where to install them
•
Configuration settings for all the WSSs and APs in the WLAN, which can be automatically deployed to the devices
by WLAN Management Software .
(For information about installing WLAN Management Software and creating and verifying a network plan, see the
Nortel WLAN Management Software User's
Installation location
Caution!
connect the mains plug to the mains. When disconnecting the earthing connection, make
sure to disconnect only after you pull out the mains plug for the mains.
Caution!
loss of equipment functionality or permanent damage.
Caution!
natural convection cooling and requires free entry of air. Airflow blockage can cause the
system to overheat and result in a loss of equipment functionality or permanent damage.
2380 switch fans and air inlets are located on the sides of the switch. 2360/2361 switch fans are located in the rear of the
switch and air inlets are located on the sides of the switch. In the 2380 switches, separate power supply fans are located
on the front. Make sure these areas have adequate ventilation after installation. Do not block air vents.
Nortel WLAN—Security Switch 2300 Series Installation and Basic Configuration Guide
Guide.)
For installations in Japan: Provide an earthing connection before you
Do not stack 2350 switches. Stacked 2350 switches can overheat and cause
Ensure adequate airflow around 2350 switches. The 2350 switch uses
Installing and connecting a WSS 37
Advertisement
Table of Contents
Troubleshooting
