D-Link NetDefend DFL-210 Cli Reference Manual page 118

3.29.1. OSPFArea
For point-to-point and point-to-multipoint networks, specify the IP addresses of directly connected
routers.
Properties
Interface
IPAddress
Metric
Comments
3.29.1.3. OSPFAggregate
Description
An aggregate is used to replace any number of smaller networks belonging to the local (intra) area
with one contiguous network which may then be advertised or hidden.
Properties
Network
Advertise
Comments
3.29.1.4. OSPFVLink
Description
An area that does not have a direct connection to the backbone must have at least one area border
router with a virtual link to a backbone router, or to another router with a link to the backbone.
Properties
Name
RouterID
UseDefaultAuth
AuthType
AuthPassphrase
AuthMD5ID
AuthMD5Key
Comments
Specifies the OSPF interface of the neighbor. (Identifier)
IP Address of the neighbor.
Specifies the metric of the neighbor. (Optional)
Text describing the current object. (Optional)
The aggregate network used to combine several small routes. (Identifier)
Advertise the aggregate. (Default: Yes)
Text describing the current object. (Optional)
Specifies a symbolic name for the virtual link. (Identifier)
The ID of the router on the other side of the virtual link.
Use the authentication configuration specified in the OSPF process.
(Default: Yes)
Specifies the authentication type for the OSPF protocol exchanges.
(Default: Null)
Specifies the passphrase used for authentication. (Optional)
Specifies the MD5 key ID used for MD5 digest authentication.
A 128-bit key used to produce the MD5 digest. (Optional)
Text describing the current object. (Optional)
Chapter 3. Configuration Reference
108