System Q; Audio Control - Kenwood DPX-MP7090U Instruction Manual

System Q

Selecting the best sound setting preset for
different types of music.
1
Select the source to set
Press the [SRC] button.
2
Select the Sound type
Press the [Q] button.
When you press the button once, the current
sound setting is displayed.
Each time you press the button, the sound
setting alternates.
Sound setting
User memory
Rock
Pops
Easy
Top 40
Jazz
Natural
• User memory: The values set on the <Audio Control>
(page 11).
• Change each setting value with the <Speaker
Setting> (page 13).
First, select the speaker type with the Speaker setting.

Audio Control

1
Select the source to adjust
Press the [SRC] button.
2
Enter Audio Control mode
Press the [VOL] knob.
3
Select the Basic Audio item to adjust
Press the [VOL] knob.
Each time you press the knob, the item to be
adjusted alternates between the items shown in
the table below.
4
Adjust the Basic Audio item
Display
Turn the [VOL] knob.
"USER"
Adjustment Item
"ROCK"
Rear Volume *
"POPS"
Subwoofer level*
"EASY"
Bass level*
"TOP 40"
Middle level*
"JAZZ"
Treble level*
"NATURAL"
Balance
Fader*
Exit Audio Control mode (Volume control mode)
• *
• *
• *
• *
• *
5
Exit Audio Control mode
Press any button.
Press a button other than the [VOL] knob and
[ATT] button.
Display
1
"Rear Volume" 0 — 35
2,3 "Sub-W Level" –15 — +15
4
"Bass Level"
4 "Middle Level" –8 — +8
4
"Treble Level"
"Balance"
3
"Fader"
1
You can control this item when "2 ZONE" of <Audio
Setup> (page 12) is set to "ON".
2 You can control this item when <Subwoofer
Output> (page 13) is set to "SW ON".
3 You can control this item when "2 ZONE" of <Audio
Setup> (page 12) is set to "OFF".
4
You can adjust these items in detail. Refer to
<Adjusting the detail of Audio Control>(Page12).
4
Source tone memory: Puts the set up value in the
memory per source. (Detail Audio item is included)
Range
–8 — +8
–8 — +8
Left 15 — Right 15
Rear 15 — Front 15
11
|
English