Connecting Wires to Terminals
To connect these leads, refer to the
relevant instruction manuals.
To Kenwood disc changer/
External optional accessory
Fuse (10A)
Power control wire (Blue/White)
Motor antenna control wire (Blue)
TEL mute wire (Brown)
External amplifier control wire
(Pink/Black)
Dimmer control wire (Orange / White)
Ignition wire (Red)
Battery wire (Yellow)
Ground wire (Black) - (To car chassis)
38
|
English
Wiring harness
(Accessory1)
If no connections are made, do not let the wire come out from the tab.
White/Black
White
FRONT L
Gray/Black
Gray
FRONT R
Green/Black
Green
REAR L
Purple/Black
Purple
REAR R
FM/AM
antenna input
Front left output (White)
Front right output (Red)
Rear left output (White)
Rear right output (Red)
When using the optional power amplifier, connect
to its power control terminal.
P.CONT
Depending on what antenna you are using,
connect either to the control terminal of the
motor antenna, or to the power terminal for the
ANT. CONT
booster amplifier of the film-type antenna.
Connect to the terminal that is grounded when
either the telephone rings or during conversation.
MUTE
To connect the Kenwood navigation
system, consult your navigation manual.
To "EXT.AMP.CONT. " terminal of the amplifier
EXT. CONT
having the external amp control function.
To car light control switch
ILLUMI
To front left
speaker
To front right
speaker
To rear left
speaker
To rear right
speaker
ACC
Car fuse box
AUX left input (White)
AUX right input (Red)
Sub Woofer left output (White)
Sub Woofer right output (Red)
Ignition key
switch
Car fuse box
(Main fuse)
–
+