Condensate Connection - Worcester GREENSTAR 24i Junior Installation Instructions Manual

4.6

CONDENSATE CONNECTION

Never terminate or discharge into any open source,
including; sink, bath, shower, bidet, toilet etc.
NOTICE: Any external condensate pipe work
must be protected with weather resistant
insulation to help prevent freezing.
• Ensure that the condensate drain is a 22mm diameter
plastic pipe. The pipe must fall at least 50mm per metre
towards the outlet.
Do not use lubricants or sealing compounds.
1. Remove the sump blanking cap from the sump.
B Fill syphon with 200 to 250 millilitres of water.
Fig. 42 Remove blanking cap
NOTICE: Pull the fan lead, DHW NTC sensor
lead and ignition cable out of the way when
fitting the syphon to ensure that they are not
trapped by the syphon assembly or
discharge hose.
To fit the syphon assembly:
B Remove orange seal retainer and discard.
Fig. 43
6 720 644 741a (2010/10)
1.
6720643895-36.1Wo
1. Push the syphon onto the sump assembly, until the
lug on the sump is fully engaged with the slot on the
back of the syphon assembly and the clip is engaged
in the top of the syphon.
NOTICE: Do not use solvents, adhesive or
lubricant when pushing the pipe onto the
rubber connector.
2. Push the discharge hose, onto the wall frame
connector, until fully engaged.
2.
Fig. 44 Fitting syphon
Maintenance
There is no need to remove the Syphon Assembly for
servicing unless cleaning is required.
To drain debris from the syphon, during the annual
service:
B Release the clips and remove the drainage cap (1)
from the bottom of the syphon.
B Empty the debris and condensate from the syphon
into a suitable container.
B Ensure that the drainage cap and seal are completely
clean.
B Re-fit the drainage cap to bottom of the syphon.
Fig. 45
INSTALLATION
1.
6720643895-37.1Wo
1
6720644741-09.1Wo
33