Swingaway Footrest Height Adjustment - Invacare 9000 Jymni Pediatric Series Maintenance Manual

SECTION 4—FRONT RIGGINGS

Swingaway Footrest Height Adjustment

NOTE: For this procedure, refer to FIGURE 4.2.
1. Remove the swingaway footrest assembly. Refer to Installing/Removing the
Swingaway Footrest Assembly on page 31.
NOTE: Lay the assembly on a flat surface to simplify this procedure.
2. Remove impact guards and/or calf strap, if necessary.
3. Perform one of the following:
A. Wheelchairs equipped with 80° swingaway footrest (Model Number J932A-14):
• Loosen, but do not remove the bolt and lock nut that secure the lower footrest
assembly to the upper footrest support.
• Reposition the lower footrest assembly to the desired height.
• Securely tighten the bolt and locknut.
B. Wheelchairs equipped with 70° swingaway footrest (Model Number J932A) OR
90° swingaway foot-rest (Model Number J933A):
• Remove the bolt, locknut and four washers that secure the lower footrest
assembly to the upper footrest support.
• Align the mounting hole of the lower footrest assembly with desired height
adjustment hole in the lower footrest support.
• Reinstall the bolt through the desired height adjustment hole in the lower
footrest assembly and through the mounting hole in the lower foot-rest
support. Securely tighten with the locknut and four washers.
4. Repeat this procedure for the other footrest, if necessary.
5. Replace impact guards and/or calf strap, if necessary.
6. Reinstall the swingaway footrest assembly. Refer to Installing/Removing the
Swingaway Footrest Assembly on page 31.
Bolt and
Locknut
Lower Footrest
Assembly
FIGURE 4.2 Swingaway Footrest Height Adjustment
9000 Jymni™Pediatric Series
J932A-14
Upper Footrest
Upper Footrest
Support
Lower Footrest
Assembly
32
Support
Locknut
Washers
J932A and
J933A
Bolt
Part No 1100868