Precor PRECISION SERIES Quick Start Card page 96

6. Secure the stabilizer to the base frame using four ⁵ ₁₆-inch x ³ ₄-inch hex head
screws and four ⁵ ₁₆-inch washers.
Note: If you encounter difficulty aligning the base mounts, loosen the clamp
screws and realign the stabilizer. Tighten the clamp screws once you have
attached the stabilizer to the base frame.
Figure 18: Base frame attachment
7. Secure the stabilizer to the handlebar shaft by fully tightening the clamp
screws.
8. Repeat this procedure, except for data cable connection, to attach the other
stabilizer.
Assembling the Equipment
To attach the handlebar shaft covers:
1. Locate the four covers (two sets) for the handlebar shaft.
2. Slide a bottom cover into place under the handlebar shaft and secure
it using two #8 self-tapping screws.
3. Secure the top cover using two #8 self-tapping screws.
Figure 19: Handlebar shaft cover attachments
4. Repeat steps 2 and 3 to attach the other set of covers.
11