Removing And Reinstalling The Front Bezel - Lenovo ThinkStation 4215 Hardware Maintenance Manual

Removing and reinstalling the front bezel

This section provides instructions on how to remove and reinstall the front bezel.
To remove and reinstall the front bezel, do the following:
1. Remove all media from the drives and turn off all attached devices and the
2. Remove the computer cover. See "Removing the computer cover" on page 87.
3. Remove the front bezel by releasing the three plastic tabs on the left side and
Figure 7. Removing the front bezel
4. To reinstall the front bezel, align the three plastic tabs on the right side of the
5. To complete the installation, go to "Completing the FRU replacement" on page
Attention
Do not open your computer or attempt any repair before reading and
understanding the "Important safety information" in the ThinkStation Safety
and Warranty Guide that came with your computer. To obtain a copy of the
ThinkStation Safety and Warranty Guide, go to:
http://www.lenovo.com/support
computer. Then, disconnect all power cords from electrical outlets and
disconnect all cables that are connected to the computer.
pivoting the front bezel outward.
front bezel with the corresponding holes in the chassis, then pivot the front
bezel inwards until it snaps into position on the left side.
122.
Chapter 9. Replacing FRUs
89