Replacing The Secondary Hard Disk Drive - Lenovo ThinkStation 4215 Hardware Maintenance Manual

11. Align the pivot pin on the hard disk drive cage with the slot 1 in the upper
12. Connect the signal cable and the power cable to the new hard disk drive.
13. Press down on the metal latch 2 and pivot the drive cage into place. Then,
Figure 28. Installing the primary hard disk drive

Replacing the secondary hard disk drive

drive cage, as shown in Figure 28. Then, slide the drive cage with the new
hard disk drive into the chassis.
slide the drive cage to the front of the computer until it snaps into position.
Note: There are two arrows, one on the upper drive cage and one on the hard
disk drive cage. The arrows are aligned when the hard disk drive is in
the proper position.
What to do next:
v To work with another piece of hardware, go to the appropriate section.
v To complete the replacement, go to "Completing the FRU replacement" on
page 122.
Attention
Do not open your computer or attempt any repair before reading and
understanding the "Important safety information" in the ThinkStation Safety
and Warranty Guide that came with your computer. To obtain a copy of the
ThinkStation Safety and Warranty Guide, go to:
http://www.lenovo.com/support
Chapter 9. Replacing FRUs
109